Nothing is better for our bathroom than a toilet that shines and smells clean! The trick that we share with you in this article is not only beneficial for the hygiene of your toilet, but also an inexpensive way to solve many problems. Let’s take a closer look at it all.

If there is one area in the bathroom that calls us to disinfect and keep it clean, it is the toilet bowl. The walls turn yellow under the influence of standing water, not to mention the lime scale that can form on the bottom of the porcelain throne. Yes, the task is clearly not the most pleasant. But what if we told you that a simple little plastic bottle could help you clean this area effortlessly? Discover now one of the most ingenious natural cleaning methods to restore your toilet to its full glory.

How do I clean the dirty toilet bowl using the bottle method?

Before proceeding with the method, we are interested in, you need to do a first step before going to bed. First, pour a handful of baking soda into the toilet and then a small amount of white vinegar. It is the foaming effect that comes from the two ingredients that we are looking for here to effectively and naturally loosen dirt from the walls of the bowl. Leave on for 15 minutes or even overnight, then gently rub with a clean toilet brush to remove debris and bad odors. Now for the said method. It involves placing a small bottle in the toilet cistern so that you can clean the bowl every time you flush. You don’t need much to do this and the steps are quick!

The bottle method to easily get a clean and white toilet

  • Get a half quart plastic bottle;
  • Pour liquid soap into the bottle;
  • Add 1 cup of white vinegar and close the bottle;
  • Shake to make sure the soap and white vinegar mix properly;
  • Pierce the top of the plastic cap;
  • Open the tank cap, insert the bottle and close it. Just be careful not to block the rinsing; mechanism with the bottle.

This way, the mixture of cleaning ingredients will immediately act on the walls of the toilet bowl every time you flush. Convenient, no? And even more so because this technique will easily perfume your bathroom and allow you to keep your toilets constantly disinfected! Another important detail, this trick allows you to reduce the amount of water in the tank. And since the tank holds less water, this means that your consumption will be lower each time you go to the toilet. This is clearly a tip that more people would benefit from adopting!

Use a plastic bottle to unclog the toilet

Want to unclog the toilet and don’t have a plunger? A plastic bottle can help you a lot:

First, cut off the bottom of a quart bottle with a knife or scissors and save the lid. Place the cut bottom of the bottle on the bottom of the bowl and then move it back and forth as if you were using a suction cup. If the blockage is not substantial, the technique should prove successful.

How do you use a plastic bottle to clean the bottom of a dirty toilet?

Often, there is no better container for cleaning products than the good old plastic bottle, simply because it is the most accessible. To effectively clean the bottom of the toilet with it, the steps are very simple:

  • Start by heating some water and then add a natural detergent like white vinegar. You can opt for a mixture that consists of a glass of lemon juice and a tablespoon of baking soda.
  • Mix everything well and pour the solution into a plastic bottle and seal it.
  • Pierce the plastic cap of the bottle.
  • Aim the neck of the bottle at the bottom of the toilet, and then gently squeeze to spray the cleaning water onto the bottom of the toilet. Two to four jets should be enough.
  • LET IT WORK
  • Take your toilet brush to scrub and then flush the toilet. Repeat as needed.

How can you naturally descale the toilet?

There are a handful of natural detergents with descaling properties such as baking soda, hydrogen peroxide, salt or lemon juice. They are a worthy alternative to aggressive chemical agents, since they completely respect the environment. To decalcify your toilet with them, you can do the following:

  • Prepare a mixture of water, 2 tablespoons of baking soda, 1 tablespoon of coarse salt and 1/4 glass of lemon juice;
  • Pour the solution into a small plastic bottle that will fit in the cistern;
  • Stir well to mix the ingredients together;
  • Put the bottle in the tank and close it;
  • Leave to soak for 30 minutes;
  • Flush the toilet. Over the course of days, the lime scale should gradually break down as the toilet flushes;

Yes, a simple plastic bottle can be super handy to solve more than one toilet problem.