To have a shiny and glossy sink like new, simply apply this old and economical cleaning method.

Buying a steel sink means wanting to add a touch of class to your kitchen area, with valuable functional cues that most people will embrace. However, even this popular material has drawbacks, especially when cleaned with unsuitable and corrosive products. Steel is prone to scratches and stains over time, losing its natural luster and forming a troublesome patina. There is an age-old method that can be used immediately, even a cheap one, to have the sink shiny and clean again, as if it had just been purchased. Let’s find out together what it is.

Steel sink ruined, what are the causes?

As mentioned above, buying a steel sink gives that value that accentuates the entire living environment. There are many not only aesthetic advantages in the use of this material, but also disadvantages if it is not used and cleaned optimally. It is important that a steel sink – given its sensitivity – is treated with products that do not discolor or dull it.

Over time, steel tends to get scratches and also lose its shiny patina until it becomes old and aesthetically unappealing. Then, when you add the use of chemicals with corrosive agents, it becomes difficult to go back.

But how do you get to all this? The main causes of a damaged and dirty steel sink are wear and tear, inattention when washing dishes and the use of unsuitable products. In addition, after use, the steel should be completely dried to remove excess water and moisture.

On the contrary, if you leave it completely wet, you may notice stains that are difficult to remove over time. Experts wanted to give a little advice for adopting a method from the past, which is essential for restoring the natural beauty of steel.

Old method to clean the steel of the sink: Two ingredients are enough

It is important to treat the vinegar well and – at least once a week – clean this surface with the old method that the experts illustrate. The main ingredients are detergent and baking soda. Pour two drops of dishwashing liquid together with a spoonful of baking soda on the surface and leave it for a few minutes. Immediately afterward, run the brush through with soft bristles or a cloth and try to apply gentle pressure to the areas of most interest. Rinse thoroughly and then wipe with a cloth to remove all traces of water and moisture. To perform this work optimally, it is best to repeat it once a week, so that the steel is always alive and shiny and deeply nourished by the direct action of the sodium bicarbonate.